Pouring the Rotor
|
Step 1
Locate the rotor mold.
|
|
Step 2
Place metal clamp against tabs on both sides of mold, then tighten clamp. (If clamp is missing, use twisted rope)
|
|
Step 3
Wipe inner face of the outer rotor mold with cooking grease. This ensures an easy release of the concrete from the mold.
|
|
Step 4
Locate inner rotor mold and plastic membrane.
|
|
Step 5
Wipe smooth surface of the inner rotor mold with cooking grease.
|
|
Step 6
Place plastic membrane sheet over surface of mold.
|
|
Step 7
Install shortest threaded rods with nut on both sides of mold.
|
|
Step 8
Insert shaft into center hole threaded end first.
|
|
Step 9
Assemble the stool by attaching legs.
|
|
Step 10
Place outer rotor mold on stool.
|
|
Step 11
Slide inner rotor mold onto shaft.
|
|
Step 12
Spin wing nut onto shaft thread.
|
|
Step 13
Fit wooden clamp to exposed shaft, keeping inner rotor mold pressed into the outer rotor mold.
|
|
Step 14
Pour concrete to bottom of inner rotor mold lip.
LET STAND 24 HOURS.
|
|